Table of Contents
Advertisement
• The expansion port connectors (
header connectors. These connectors can be used to access the
ADSP-2189M signals for expansion or test purposes. For more
information, see
• The
P6
ADDS-218x EZ-ICE in-circuit emulator. Pin 7 should be removed
for keying purposes. For more information, see
tor" on page
• The
P7
to supply power to the board. The center pin of the jack is 2.5 mm
diameter and should connect to the positive side of the power
source. The outer sleeve of the mating plug must be ground.
• The
P8
communicate with a host computer using RS-232 signal levels and
asynchronous serial protocols.
Expansion Port Connectors
Three expansion port connectors (
ADSP-2189M processor's interface pins, letting you watch data transmis-
sions. The
,
P3
connectors. These connectors can be used to access the ADSP-2189M sig-
nals for expansion or test purposes. In addition, all interrupts, bus signals,
and
PWT_EVENT
numbers on these connectors are arranged as follows.
Figure 3-3. Expansion Connector
ADSP-2189M EZ-KIT Lite Evaluation System Manual
"Expansion Port Connectors" on page
connector is a 14-pin header connector connects to an
3-12.
connector is a jack for a 6.35 mm cylindrical plug. It is used
connector is a male 9-pin D-Sub connector. It is used to
, and
connectors are sites for 50-pin header
P4
P5
signals are available through the expansion port. The pin
EZ-KIT Lite Hardware Reference
,
, and
P3
P4
P5
,
, and
) provide access to the
P3
P4
P5
) are sites for 50-pin
3-9.
"EZ-ICE Connec-
3-9
Advertisement
Table of Contents
Need help?
Do you have a question about the ADSP-2189M EZ-KIT Lite and is the answer not in the manual?