Installing Visualdsp++ And Ez-Kit Lite Software - Analog Devices ADSP-2189M EZ-KIT Lite Manual

To configure your board to take advantage of the audio capabilities of the
demos, use the following procedure.
1. Plug a set of self-powered computer speakers into jack
board. Turn on the speakers and set the volume to an adequate
level.
2. Connect the line out of an electronic audio device to jack
board. Set jumper
3. Open Jumper
the board default).
This completes the hardware installation. For information about the
EZ-KIT Lite hardware design, refer to

Installing VisualDSP++ and EZ-KIT Lite Software

This EZ-KIT Lite comes with the latest version of VisualDSP++ for 16-bit
processors. VisualDSP++ installation includes EZ-KIT Lite installations.
To install VisualDSP++ and EZ-KIT Lite software:
1. Insert the VisualDSP++ installation CD into the CD-ROM drive.
2. If Autoplay is enabled on your PC, you see the Install Shield Wiz-
ard Welcome screen. Otherwise, choose Run from the Start menu,
and enter
of your local CD-ROM drive.
3. Follow the on-screen instructions to continue installing the
software.
4. At the Custom Setup screen, select your EZ-KIT Lite from the list
of available systems and choose the installation directory.
Click an icon in the Feature Description field to see the selected
system's description. When you have finished, click Next.
ADSP-2189M EZ-KIT Lite Evaluation System Manual
to
JP3 LINE
to to enable the AD73322 codec. (This is
JP2 GND
D:\ADI_Setup.exe
.
"Board Layout" on page
in the Open field, where
Getting Started
on the
J2
on the
J1
3-3.
is the name
D
1-5