Transfer Trend Data; File Name Format For Uploaded Files - Ametek AMEVision User Manual

Transfer Trend Data

1. Using a standard 7/16" wrench, loosen and remove the nut on the left side
2. Locate the plug-in port for the USB flash drive and plug the drive into the
3. Navigate to the Transfer Trend Data button and press ENTER/MENU. A
4. The message "Transferring Data to USB" is displayed.
5. The upload is successful when the next screen displays a large GREEN

File Name Format for Uploaded Files

Analyzer Name Month (2)
WDG1 August
WDG1 08
6. Press CANCEL to exit the menu.
3-16 | Thermox ® AMEVision Display User Interface
of the AMEVision enclosure to open the AMEVision enclosure door.
port on the AMEVision enclosure.
screen will display asking if you have plugged in the USB drive. Select OK
and press ENTER/MENU.
check mark indicating the Trend Transfer was successful.
Day (2) Year (4) Hour (24)
21st 2012 1 PM
21 2012 13
WDG108212012132741_plog1.txt
plog (1,2, 3)
Three (3) files are stored on the flash drive when you upload trend data
files. The filenames end with the specific sequential file (i.e., plog1,
plog2, plog3).
The extension for uploaded Trend Data files is .txt.
If the upload was not successful, a large RED 'X' will appear on the
display with the message "Failed." You will be asked if the USB was
plugged in. Check the USB drive to make sure it is connected and try
again. If you continue to fail to upload the trend data, contact
AMETEK customer service.
Minute (2) Second (2) _Plog 1,2,3 (
27 min 41 sec plog 1
27 41 _plog1.txt
PN 9000-165-VE, Rev P