Important Notice To Users - Ametek AMEVision User Manual

Important Notice to Users

The AMEVision Display User Interface is suitable for the following locations:
- Class I, Zone 2, Group IIC
- Class I, Zone 22, Group IIB
- Class I, Division 2, Group A, B, C, D
- Class II, Division 2, Group E, F, G
No operator serviceable components inside any components of the AMEVision. Refer
servicing to qualified personnel. Power, input, and output (I/O) wiring must be in
accordance with Class I, Division 2 wiring methods [Article 501-4(b) of the National
Electric Code, NFPA 70] and in accordance with the authority having jurisdiction.
PN 9000-165-VE, Rev P
Explosion hazard – Substitution of components may impair suitability for Class I,
Class II, Division 2.
Explosion hazard – When in hazardous locations, turn off power before replac-
ing or wiring modules.
Explosion hazard – Do not disconnect equipment unless power has been
switched off or the area is known to be nonhazardous.
This equipment is suitable for use in Class I, Division 2, Groups A, B, C and D,
Class II, Division 2, Group E, F and G or Nonhazardous locations only.
Exposure to some chemicals may declare the sealing properties of materials
used in the following devices: Power Supply Module.
Explosion Hazard. When in hazardous locations, turn off power before removing
or replacing wiring, modules, battery or components unless the area is known to
be free of ignitable concentrations of flammable gases or vapors.
Substitution of the following components may impair suitability for Division 2
power supply.
Battery must be replaced with AMETEK part number 1000-652-VE.
Contents | ix