Amevision Host Display Mains Supply Connections - Ametek AMEVision User Manual

AMEVision Host Display Mains Supply Connections

The AMEVision Host Display can operate using between 85–250 volts AC,
47–63 Hz. There is no power switch or circuit breaker on the control unit, and
it must be protected by installing it on a circuit-protected line, maximum 15
amperes, with a switch or circuit breaker in close proximity to the control unit
and within easy reach of an operator. Mark the switch or circuit breaker as the
control unit disconnecting device.
Mains supply connections to the control unit are as follows:
•
•
•
Use the 1/2" conduit entry hole for AC mains supply wiring. Use the chassis
stud next to the 1/2" conduit entry hole for equipment ground (protective
conductor).
AC (L) and (N) markings are provided by the terminal block for connection of
AC power. These markings are for reference purposes only, such as for use on
system wiring diagrams, etc. The system/product has or needs no specific LINE
or NEUTRAL connection for any function, safety or otherwise. The (N) terminal
is not internally grounded, nor needs to be. The system will operate normally
regardless of what AC input terminal (L or N) the AC Line or Neutral is con-
nected to, or, if there is a Neutral used at all (i.e., 208 VAC US power connec-
tion).
PN 9000-165-VE, Rev P
Line – Line connection
Neutral – Neutral connection (USA)
Chassis Stud – Equipment ground (protective conductor)
Overview and Installation
|
1-3