Usb Transfer Utility; Transfer Sensor Parameters - Ametek AMEVision User Manual

USB Transfer Utility

Use this menu to upload data to a USB flash drive for use on a computer.
1. Press the Left or Right arrows to locate the USB Transfer menu and press
2. Press ENTER/MENU to access the USB Transfer screen.
3. From the USB Transfer screen, you can transfer Sensor Parameters and

Transfer Sensor Parameters

1. Using a standard 7/16" wrench, loosen and remove the nut on the left side
2. Locate the USB port inside the AMEVision enclosure (Figure 3-8) and insert
3. Select the Transfer Sensor Parameters button and press ENTER/MENU.
4. The message "Transferring Data to USB" is displayed.
5. The upload is successful when the next screen displays a large GREEN
3-14 | Thermox ® AMEVision Display User Interface
Uploads are carried out using a USB flash drive. It is necessary to plug
the USB flash drive into the USB port inside the AMEVision enclosure to
upload the data.
ENTER/MENU.
Trend Data, as described in the following pages.
of the AMEVision enclosure to open the AMEVision enclosure door.
the USB flash drive into the port.
A screen will display asking if you have plugged in the USB drive. Select OK
and press ENTER/MENU.
check mark indicating the Parameter Transfer was successful.
PN 9000-165-VE, Rev P