Control Diagnostics - Ametek AMEVision User Manual

Control Diagnostics

1. Press the Left or Right arrows to locate the Control Diagnostics menu and
2. There are three screens that make up the Control Diagnostics menu:
Figure 3-1.
Set Analog Value screen
(Diagnostics Mode).
3-4 | Thermox ® AMEVision Display User Interface
Diagnostics Mode is turned on when changes are made on this
menu so that the system does not accidentally trigger an auto calibra-
tion while troubleshooting.
press ENTER/MENU.
When you press ENTER/MENU key, the message "Diagnostics Mode:
Off" appears on the Status Bar at the bottom of the screen. This
changes to "Diagnostics Mode: On" if you make any changes. Press
CANCEL to exit and turn off Diagnostics Mode.
Analog I/O, Relays, and Close Contact.
This screen displays the three Outputs available, the Set Values, and the
Actual Values. Use the arrows to access the Set Value fields and the nu-
meric keypad to change the values.
Making a change to any of these fields will turn on the Diagnostics
Mode. Press CANCEL to exit Diagnostics Mode.
PN 9000-165-VE, Rev P