Sensor (Analyzer) Name Configuration - Ametek AMEVision User Manual

Sensor (Analyzer) Name Configuration

Figure 2-4.
Sensor (Analyzer) Name
Configuration screen.
1. From the Main Menu screen, press ENTER/MENU to access the Configu-
2. Press the Left or Right arrows to locate the System Name Configuration
3. Use the keypad to enter the name(s) of your analyzer(s). Enter the name as
4. Navigate to ACCEPT and press ENTER/MENU after each name to accept
2-6 | Thermox ® AMEVision Display User Interface
The default name of the analyzer is WDG-n, where 'n' is the address of
the analyzer. If you have multiple sensors, entering a name for each
sensor you want to connect is recommended but not required.
ration Menu.
menu and press ENTER/MENU.
you would on a mobile phone. The keypad displays the characters as you
enter them. For example, to select the letter 'E' press the '3' key twice. To enter
the number '2' press the '2' key four times (e.g., 'A-B-C-2. ' )
Maximum number of characters is 10.
the name of that sensor.
PN 9000-165-VE, Rev P