Perform An Automatic Calibration; Configuring The Auto Cal Using The Auto-Cal Config Menu - Ametek AMEVision User Manual

Perform an Automatic Calibration

There are two ways to perform an automatic calibration:
•
•

Configuring the Auto Cal Using the Auto-Cal Config Menu

1. From the Main Menu screen, press ENTER/MENU to access the Calibra-
2. Press the Left or Right arrows to locate the Auto Cal Config menu and
3. Press the Left and Right arrows to navigate to the next screen.
Figure 2-15.
Auto-Calibration
Configuration screen.
PN 9000-165-VE, Rev P
The functions for automatic calibration will only be visible if you have
an RCU and have configured your sensor for Automatic Calibration
in the Sensor Configuration menu.
Define the automatic calibration time and date in the Auto-Calibration
Configuration (Auto Cal Config) menu. This allows the system to perform
calibrations at scheduled times and there is no further user interaction.
Use the Start Calibration (or Set Cal Gas) menu to define the gases and
values and then use the Start Calibration menu to perform an immedi-
ate calibration. This requires you to program the Start Calibration menu
and physically press ENTER/MENU to start the calibration. The real-time
sequence of calibration events is displayed on a series of screens which
require user before each step of the calibration continues.
tion Menu.
press ENTER/MENU.
|
Controller/Interface 2-21