Storage And Transport - Beko METPOINT BDL compact Installation And Operating Manual

EN

5. Storage and transport

Despite our best efforts regarding packaging, etc., the device might be damaged during transport. Upon receipt, please
remove all packaging material and inspect the METPOINT
immediately notify the carrier company and BEKO TECHNOLOGIES or one of its agents.
WARNING! Overheating
Overheating can damage the evaluation electronics. Observe the permissible storage, transport and
operating temperature (protect measuring device from direct sunlight).
WARNING! Risk of damage
Incorrect transport or storage, or the use of unsuitable lifting equipment might cause damage to
the METPOINT
Preventive measures
• The METPOINT BDL compact must only be transported and stored by authorised and suitably *skilled technical
®
personnel.
• To transport the device, use only suitable lifting gear that is in proper working order.
• Always observe the relevant statutory requirements.
CAUTION! Risks from damaged components!
If you suspect that the METPOINT
might impair the operational safety of the METPOINT
measurements and lead to serious damage.
*Skilled technical personnel
Skilled technical personnel are persons who, due to their professional qualification and knowledge in the field of measuring,
control and pneumatic technology, and their knowledge of the applicable statutory regulations, guidelines and standards
are in a position to foresee potential dangers in relation to the use of the device and who are qualified to perform the tasks
described in this manual.
Special operating conditions (e.g. aggressive media) require additional knowledge.
METPOINT BDL compact
®
BDL compact for visible damage. If you detect such damage,
®
BDL compact.
®
BDL compact is damaged, do not start it. Defective components
®
Installation and operating manual
BDL compact or result in incorrect
®
The METPOINT BDL compact must be stored
®
in the original packaging. Seal the packaging and
store it in a dry and frost-free room. Ensure that
the storage temperature does not exceed the
limits specified on the type plate.
Even when packaged, take suitable measures
to protect the METPOINT
®
elements.
While in storage, secure the METPOINT
compact so that it cannot topple over or fall,
and protect it against vibration.
BDL against the
BDL
®
9