Transport And Storage - Beko METPOINT FLM SF53 Installation And Operating Manual

Installation and operating manual

1.4. Transport and storage

Despite our best efforts, transport damage cannot be excluded. Please therefore remove all packaging material immediately after
receipt and inspect the product for any possible transport damage. If you detect such damage, immediately notify the carrier
company and BEKO TECHNOLOGIES GMBH or one of its agents.
CAUTION Damage caused during transport or storage
Incorrect transport or storage, or the use of unsuitable lifting equipment, might cause damage to the
device.
•
•
•
•
NOTE Recycling packaging material
•
6
The device must only be transported and stored by authorised and suitably trained skilled technical
personnel.
If you detect any damage, do not start the device.
Always comply with the permissible storage and transport temperatures (refer to technical data).
Never expose the device to continuous, direct sunlight or heat radiation.
The packaging material is recyclable. Dispose of the packaging material according to the applicable
statutory regulations.
The device must be stored in its original packaging.
Seal the packaging and store it in a dry and frost-
free room. Ensure that the ambient conditions do
not fall below or exceed the limits
specified on the type plate.
Even when packaged, take suitable measures to
protect the device against the elements.
While in storage, secure the device so that it
cannot topple over or fall, and protect it against
vibration.
EN
METPOINT SF53
®