Connecting The Metpoint ® Bdl Compact With A Pc - Beko METPOINT BDL compact Installation And Operating Manual

Installation and operating manual
10. Connecting the METPOINT
NOTICE Static IP address
The IP addresses of the PC and the METPOINT
the same network.
If the IP address of the METPOINT
IP address of BDL compact: see chapter 11.2.3.3
Restarting BDL compact: see chapter „11.2.3.7.5. Restoring factory settings" page 74
To connect the METPOINT
ends. Alternatively use an Ethernet cable with a crossover adapter.
Crossover cable with RJ45 plug-type connectors
After the METPOINT BDL compact has been connected to the PC, you can use the METPOINT
®
for the evaluation of data in the form of charts and tables.
Network settings for Windows PC:
Windows 7:
Start  Control Panel  Network and Sharing Center  Change adapter settings  LAN Connection  Properties 
Internet Protocol Version 4 (TCP/IPv4) Use the following IP address  Enter the IP address and subnet mask
Then: OK  OK  Close
Windows Vista:
Start  Control Panel  Network and Sharing Center  Manage network connections  LAN Connection 
Properties  Internet Protocol Version 4 (TCP/IPv4) Use the following IP address  Enter the IP address and subnet
mask
Then: OK  OK  Close
Windows XP:
Start  Settings  Control Panel  Network Connection  LAN Connection  Properties  Internet Protocol (TCP/IP)
 Use the following IP address  Enter the IP address and subnet mask.
Then: OK  OK  Close
42
BDL compact with a PC
®
BDL compact to a PC, use an 8-wire crossover cable with RJ45 plug-type connectors at both
®
BDL compact must be static (DHCP off) and part of
®
BDL compact has been changed, you must restart the device!
®
Crossover adapter
READER SW201 software
®
METPOINT BDL compact
®
EN