Beko METPOINT BDL compact Installation And Operating Manual page 62

Installation and operating manual
 Settings Sensor-settings
Home
Important:
Ensure that the correct Register address
The register address might deviate from the register number (offset). For details, refer to the sensor/transducer data sheet.
 Settings Sensor-settings
Home
Supported data types:
Data Type: UI1(8b) = unsigned integer
I1 (8b) = signed integer
UI2 (16b) = unsigned integer
I2 (16b) = signed integer
UI4 (32b) = unsigned integer
I4 (32b) = signed integer
R4 (32b) = floating point number
Byte order:
The Modbus register has a capacity of 2 bytes. For a 32-bit value, two Modbus registers are read by the BDL. For a 16-bit
value, only one register is read.
The Modbus specifications do not accurately describe the byte order in which data is transferred. In order to cater for
all possible configurations, the byte order can be freely adjusted in the BDL, as it must be adjusted to match that of the
respective sensor (see sensor/transducer data sheet).
Example: high byte before low byte, high word before low word, etc.
The byte order must be configured based on the information in the sensor/transducer data sheet.
62
A1 right arrow (2. page)  Register address
is entered.
A1 right arrow (2. page)  Register format
=> 0
=> -128
=> 0
=> -32768
=> 0
=> -2147483648
The sensor stores the measured values in registers.
These values can be addressed by the BDL and read
out via Modbus.
For this purpose, specify the register addresses in
the BDL.
The Register/data address
0 and 65535.
Press the Input register and
buttons, to select the Modbus register type.
Select the Data type and the
parameters determine the numerical format and the
transmission sequence of the individual numerical
bytes.
- 255
- 127
- 65535
- 32767
- 4294967295
- 2147483647
EN
is a decimal value between
Holding register
Byte order. These
METPOINT BDL compact
®