Lockout Command - Agilent Technologies HP 16500B Manual

Programming Over RS-232C

Lockout Command

Lockout Command
To lockout the front-panel controls, use the SYSTem command LOCKout.
When this function is on, all controls (except the power switch) are entirely
locked out. Local control can only be restored by sending the :LOCKout
OFF command.
Hint Cycling the power will also restore local control, but this will also reset
certain RS-232C states. It also resets the logic analysis system to the
power-on defaults and purges any acquired data in the acquisition memory of
all the installed modules.
See Also
For more information on this command see chapter 10, "System Commands."
3–12
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com