Agilent Technologies HP 16500B Manual page 181

STORe [:CONFig]
Command :MMEMory:STORe [:CONfig]<name>[,<msus>],
<description>[,<module>]
The STORe command stores module or system configurations onto a disk.
The [:CONFig] specifier is optional and has no effect on the command. The
<name> parameter specifies the file on the disk. The <description>
parameter describes the contents of the file. The optional <module>
parameter allows you to store the configuration for either the system or the
modules. 0 refers to the system. 1 through 5 refers to the modules in the
mainframe alone and 1 through 10 refers to the mainframe with an expansion
frame connected.
If the optional <module> parameter is not specified, the configurations for
both the system and logic analyzer are stored.
A string of up to 10 alphanumeric characters for LIF in the following form:
<name>
NNNNNNNNNN
or
A string of up to 12 alphanumeric characters for DOS in the following form:
NNNNNNNN.NNN when the file resides in the present working directory
or
\NAME_DIR\FILENAME when the files does not reside in the present
working directory
Mass Storage Unit specifier. INTernal0 for the hard disk drive and
<msus>
INTernal1 for the flexible disk drive.
A string of up to 32 alphanumeric characters
<description>
An integer, 1 through 5 for the HP 16500B alone. 1 through 10 with an
<module>
HP 16501A connected.
Examples
OUTPUT XXX;":MMEM:STOR 'DEFAULTS','SETUPS FOR ALL MODULES'"
OUTPUT XXX;":MMEMORY:STORE:CONFIG
'ANALYZER 1 CONFIG',1"
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
MMEMory Subsystem
STORe [:CONFig]
'STATEDATA',INTERNAL0,
11–23