HEIDENHAIN SRP 5000 Operating Instructions Manual page 36

10.1 Disassembly
Also observe the corresponding safety instructions, which
are given when installing the relevant components.
The unit is basically removed in the reverse sequence
used for mounting.
If the unit will be temporarily stored after removal, the
specified ambient conditions must be maintained.
Further information: "Encoder characteristics",
page 38
Repackaging should correspond to the original packaging
as closely as possible:
Repackage the product, foam and cardboard box insert
as originally shipped from the factory
Enclose all the documentation that were included in
the original packaging.
Further information: "Storage and distribution of the
documentation", page 23
10.2 Disposal
Incorrect disposal of the product!
Incorrect disposal of the product can cause
environmental damage.
Do not dispose of electrical waste and
electronic components in domestic
waste
Forward the product to recycling in
accordance with the applicable local
disposal regulations
If you have any questions about the disposal of the
product, please contact a HEIDENHAIN service
agency
38
NOTICE
11 Specifications
More specifications are available in the "Angle
Encoder Modules" brochure.
11.1 Encoder characteristics
Output signal
SRP 5080
Incremental signals 1 V
Reference marks 80 (distance-
coded)
Absolute -
position values
Position values -
per revolution
Clock frequency -
Processing time -
Signal periods 30000
Electrical connection
SRP 5080
DC 5 V ±0.25 V
Voltage supply
≤ 175 mA
Current consump-
tion (typical, without at 5 V
load)
≤ 950 mW
Power consumption
at 5 V
Cable length 1.5 m
(maximum cable length: 30 m)
HEIDENHAIN | Betriebsanleitung SRP 5000 | 5/2017
SRP 5010
-
PP
-
EnDat 2.2
28 bits
≤ 16 MHz
5 µs (at 8 MHz)
16384
SRP 5010
DC 3.6 V  14 V
≤ 140 mA
at 5 V
≤ 1.1 W
at 3.6 V
≤ 1.3 W
at 14 V