HEIDENHAIN SRP 5000 Operating Instructions Manual page 28

4 Mounting
4.1 Product overview
More information: "A", "B", "C", page 4
1 Mating rotor component, mounting variant A
2 Mating stator component
3 Mating rotor component, mounting variant B
4 ISO 4762–M3–8.8 screw. Materially bonding
threadlocker required. ISO 7092–3–200HV washer,
tightening torque 0.95 Nm ±0.05 Nm
5 ISO 4762–M4–8.8 screw. Materially bonding
threadlocker required. ISO 7092–4–200HV washer,
tightening torque 2.2 Nm ±0.12 Nm
6 Encoder connection
7 Grounding conductor terminal
8 Motor connection
9 ID label
Mark for 0° position ±5°
10
11 Rotor
12 Stator
a Mating dimensions, required for determination of
screw length
b Recommended direction of force; the recom-
mended direction of force is to be maintained if
dynamic overloads are possible
4.2 Mounting options
The device can be mounted in two different ways.
Mounting option A
The fastening points of the mating rotor component
mating stator component 2
of the device
Further information: "A", page 4
Mounting option B
The fastening points of the mating rotor component
mating stator component 2
of the device
Further information: "B", page 4
30
1 and
are located on opposite sides
3 and
are located on the same side
4.3 Dimensions
All required mating dimensions are depicted in the
following drawing:
Further information: "F", page 151 and following.
All dimensions in the drawings are in millimeters.
4.4 Installation
DANGER
Improper installation can result in breaking or
overloading the device.
Device components can come loose and cause injury.
If dynamic overloads are possible, maintain the
recommended direction of force
The mounting surfaces and screws must be
clean and free of grease.
Position the device on the mounting holes
Insert screws 4 and 5 with materially bonding
threadlocker and washer
Tighten screws in diagonally opposite sequence
Tighten the screws in steps up to the indicated torque
Further information: "A", page 4, page 4
HEIDENHAIN | Betriebsanleitung SRP 5000 | 5/2017