Fault Active Mode - Bacharach Neutronics Mini-ICS Operation Manual

RUN Modes
The 7-segment alphanumeric display will flash and continue to display the measured Oxygen level.
The "NORMAL" indicator LED will remain lit. The Inerting Control relays will change state
according to the analyzer configuration. The Inerting Control function will be cleared automatically
when measured Oxygen concentration falls below the set threshold value of the Low Inerting
Control Limit. The Inerting Control relays will return to their non-active state according to their
configuration.

3.3.4 FAULT ACTIVE Mode

The Model Mini-ICS initiates Fault Active mode when it has detected that one or more Fault
criterion have been satisfied (section 4.3.1). The "FAULT" indicator LED will light and the Fault
relays will change state. The Fault status will be cleared automatically when no Fault criterion
have been satisfied. The "FAULT" indicator LED will go out and the Fault relays will return to their
non-active state. The user may view active faults at any time from the front panel (section 3.2.5).
The Fault mode is not affected by activation of any user mode.
Manual Part Number: Revision Level: C Revision Date: Page
5-06-4900-53-0 ECO 044952 May 08, 2018 3-5