Table of Contents
Advertisement
3 | Safety and responsibility
3.7.12 Spare parts
3.7.13 Care and maintenance
18
Ø Do not perform any structural changes to the pulling tool of the machine.
Ø Do not make any structural changes or extensions that have not been ap-
proved by HORSCH.
Ø Modifications and extensions approved by HORSCH are only to be performed
at an authorized workshop or by an operator who has been trained by
HORSCH for this purpose.
Ø Comply with country-specific regulations for weights, weight distribution and
dimensions.
For equipment influencing the weight or weight distribution the regulations con-
cerning towing facility, support and axle load must be checked and complied with.
For machines without brakes a brake system may need to be retrofitted if the per-
missible weight limits are exceeded.
In case of changes concerning data mentioned on the type plate, a new type plate
with updated data must be attached.
In case of changes which concern the data in the type approval, this type approval
needs to be renewed.
Genuine spare parts and accessories from HORSCH have been specially designed for
this machine.
Spare parts and accessories which are not delivered by us have not been tested or
approved by us.
The installation or use of other than HORSCH products can therefore negatively af-
fect the design characteristics of the machine and thus impair the safety of man and
machine.
HORSCH will not assume liability whatsoever for damage resulting from the use of
non-original parts and accessories.
If the component to be replaced is marked with a safety sticker, these stickers must
also be ordered and attached to the spare part.
Inappropriate care and maintenance put the operational safety of the machine at
risk. This can lead to accidents with severe or even fatal physical injuries.
Ø Conform to prescribed schedules for repetitive tests or inspections.
Ø Service the machine according to the maintenance plan, see chapter Care and
maintenance.
Ø Only perform the work described in these operating instructions.
Ø Before starting maintenance and service work park the machine on level and
firm ground and secure it against rolling away.
Ø Depressurise the hydraulic system and lower or support the implement.
Ø Prior to working on the electrical system, disconnect it from the electric cur-
rent supply.
Ø When performing welding work on the machine, disconnect the cables from
electronic components. The ground connection must be as close as possible to
the welding point.
60026505 • 1 • 09/2020 • en
Advertisement
Table of Contents
