Installation Of The Product - Husqvarna Automower 305 Operator's Manual

3.5 Installation of the product

3.5.1 Installation tools
• Hammer/plastic mallet: To simplify putting the
stakes into the ground.
• Edge cutter/straight spade: To bury the boundary
wire.
• Combination pliers: For cutting the boundary wire
and pressing the connectors together.
• Adjustable plier: For pressing the couplers
together.
3.5.2 To install the charging station
CAUTION:
the charging station plate.
CAUTION:
baseplate of the charging station.
WARNING:
the low-voltage cable and the power supply
unit are clean and dry before you connect
them.
18 - Installation
D
A
B
C
Do not make new holes in
Do not put your feet on the
Make sure that the plugs of
1. Read and understand the instructions about where
to put the charging station. Refer to
where to put the charging station on page 13 .
2. Put the charging station in the selected area.
Note:
Do not attach the charging station with
the screws to the ground until the guide wire is
installed. Refer to
19 .
3. Connect the low-voltage cable to the charging
station.
4. Put the power supply at a minimum height of 30
cm / 12 in.
min 30 cm / 12"
5. Connect the power supply cable to a 100-240V
power outlet.
Note:
When the charging station is connected, it
is possible to charge the product. Put the product
in the charging station while the boundary and
guide wires are being laid. Switch on the product
to start charging the product. Refer to
the ON/OFF button on page 32 . Do not continue
with any product settings before the installation is
complete.
6. Put the low-voltage cable in the ground with stakes
or bury the cable. Refer to
position with stakes on page 19 or To bury the
boundary wire or the guide wire on page 20 .
7. Connect the wires to the charging station after
the installation of boundary wire and guide wire is
complete. Refer to
page 18 and To install the guide wire on page
19 .
8. Attach the charging station to the ground with the
supplied screws after the guide wire is installed.
To install the guide wire on page 19 .
Refer to
3.5.3 To install the boundary wire
CAUTION:
a coil. The coil causes interference with the
product.
1. Put the boundary wire around all of the work
area. Start and complete the installation behind the
charging station.
To examine
To install the guide wire on page
To use
To put the wire into
To install the boundary wire on
Do not put remaining wire in
1462 - 008 - 20.02.2023