3.1 Introduction - Installation
WARNING: Read and understand the
safety chapter before you install the
product.
CAUTION: Only use original spare
parts and installation material.
Note: Refer to www.husqvarna.com for more
information about installation.
3.2 Before the installation of the
product
•
Make a blueprint of the work area and
include all obstacles.
•
Make a mark on the blueprint where to put
the charging station, the boundary wire and
the guide wire.
•
Make a mark on the blueprint where the
guide wire connects to the boundary wire.
To install the guide wire on page
Refer to
21 .
•
Fill in holes in the lawn.
Note: Holes with water in the lawn can
cause damage to the product.
3.2.1 To examine where to put the charging
station
•
Keep a minimum 3 m / 10 ft. of free space in
front of the charging station.
•
Keep a minimum of 1.5 m / 5 ft. of free
space to the right and to the left of the
charging station.
•
Put the charging station near an outdoor
power outlet.
•
Put the charging station on a level surface.
max. 5 cm / 2"
max. 5 cm / 2"
1035 - 001 - 04.02.2019
3 Installation
•
Put the charging station in the largest open
section of the work area.
•
Put the charging station in an area without
an irrigation system.
•
Put the charging station in an area with
protection from the sun.
•
If the charging station is installed on an
island, make sure to connect the guide wire
to the island. Refer to
page 17 .
3.2.2 To examine where to put the power
supply
•
Put the power supply in an area with a roof
and protection from the sun and rain.
•
Put the power supply in an area with good
airflow.
•
Use a residual-current device (RCD) when
you connect the power supply to the power
outlet.
WARNING: Do not change the power
supply. Do not cut or extend the low-
voltage cable. There is a risk of
electrical shock.
Low-voltage cables of different lengths are
available as accessories.
To make an island on
Installation - 15