Changing The Sample Rate - Adaptec DuraStor 7220SS User Manual

Note: The controller will not boot if you disable SCSI
channel 3 while in active-active mode. You must change
your operating mode before disabling SCSI channel 3.
To disable SCSI channel 3:
1
From the System Menu, select Shutdown/Restart and press
Enter.
The system confirms that you want to shut down.
2
Select Yes and press Enter.
The system confirms that it has shut down.
3
Press Enter to reboot.
While the controller reboots, hold down the Spacebar on your
keyboard.
The Flash Utility screen appears.
4
Press 6 for the Utility menu.
The Utility menu appears.
5
Press 8 for Disable SCSI Channel 3.
The system confirms that SCSI channel 3 is disabled.
6
Press q to return to the Utility menu.
7
Press 5 to reboot the controller.
To enable SCSI channel 3 after disabling it, repeat the steps above.
The Utility menu item 8 will read Enable SCSI Channel 3.

Changing the Sample Rate

You can set how often the controller samples data when updating
status screens (disk drive and array). The default is one second.
To change the sample rate:
1
From the System Menu, select Configuration Menu and press
Enter.
The Configuration menu appears.
Configuring the Controller
5-15