4
Select the option you want and press Enter.
The system confirms that you want to make the change.
5
Select Yes and press Enter to make the change.
The system confirms that the change is made.
6
Press Esc to return to the Option Configuration menu.
Note: You must reboot the controller for the change to take
effect. See
Managing the Other Controller
If you are using active-active mode, you can
Display information about the other controller. See
I
Shut down the other controller. See
I
Shut down both controllers. See
I
Kill the other controller. See
I
Unkill the other controller. See
I
You can also change the ownership of an array between
controllers. See
Displaying Information about the Other Controller
You can view information about the other controller. If the other
controller is up, its current status is shown; if the other controller is
down, its last known state is shown. If the other controller never
communicated with the local controller since boot up, most fields
will display Unknown or something similar.
To display information about the other controller:
1
From the System Menu, select Other Controller Menu and
press Enter.
The Other Controller menu is only available if the system is
configured to run in active-active mode.
The Other Controller menu appears.
Rebooting the Controller on page
Changing Array Ownership on page
Configuring the Controller
page
5-12.
page
5-12.
page
5-13.
page
5-13.
5-2.
page
5-11.
2-18.
5-11