Trusting An Array - Adaptec DuraStor 7220SS User Manual

controller you change it to. You can no longer see the array on the
original controller.
Note: When you change the ownership of an array, the
LUNs assigned to the array's partitions become invalid.
After changing ownership, you must assign a new LUN to
each array partition.
To change array ownership:
1 From the System Menu, select Array Menu and press Enter.
The Select Array menu appears.
2 Select the array you want and press Enter.
That array's Array menu appears.
3 Select Switch Array Owner and press Enter.
The system confirms that you want to make the change.
4 Select Yes and press Enter.
5 Assign a new LUN to each array partition.
See Changing a Partition LUN on page

Trusting an Array

The Trust Array Function brings an array back online by
resynchronizing the time and date stamp and any other metadata
on a bad disk drive. This makes the disk drive an active member of
the array again. You might need to do this when
One or more disk drives of an array start up more slowly or
I
were powered on after the rest of the disk drives in the array.
This causes the date and time stamps to differ, which the
controller interprets as a problem with the late disk drives. In
this case, the array will function normally after using Trust
Array.
Creating and Managing Arrays and Partitions
2-28.
2-19