Errors; Using The Loader Diagnostics Menu - Adaptec DuraStor 7220SS User Manual

Errors

Error events let you know that something related to the storage
enclosure, controller, or disk drives has failed and requires
immediate attention.
recommends the action you should take.
Table 7-2 Error Events
Event
BATTERY
FAILED
DISK CHAN
FAILED
ENCLOSURE
FAIL
SDRAM
UNCORR
ECC
VOLT/TEMP
FAIL

Using the Loader Diagnostics Menu

If you have any diagnostic errors, contact Adaptec technical
support. (See page 7-1
Table 7-2 defines each error event and
Definition
A failure in the battery
pack and/or charging
interface has been
detected.
An error has occurred
in communicating on
the disk channel.
Enclosure-specific
general purpose I/O
triggered a failure
condition.
A noncorrectable
multiple-bit SDRAM
ECC error occurred.
The analog-to-digital
convertor monitored a
temperature and/or
voltage in the failure
range.
for contact information.)
Troubleshooting
Recommended Action
Replace the controller's
battery. Refer to DuraStor
6200SR and 312R
Installation and User's
Guide.
Check the cables on the
channel. Check the
termination on the disk
channel. Refer to DuraStor
6200SR and 312R
Installation and User's
Guide.
Check the status of the
storage enclosure. Refer to
DuraStor 6200SR and 312R
Installation and User's
Guide.
Reseat the memory. If the
problem continues, replace
the memory. Refer to
DuraStor 6200SR and 312R
Installation and User's
Guide.
Check that the controller's
fan is running. Check that
the ambient temperature is
not too warm. Refer to the
DuraStor 6200SR and 312R
Installation and User's
Guide.
7-10