Stopping The Array Initialization Process; Verifying An Array - Adaptec DuraStor 7220SS User Manual

3 Select Drive Status and press Enter.
The Display Drives menu appears showing the disk drives that
are members of the array and that are assigned as dedicated
spares.
↑
Use the or
the drives that are currently members of the array.
4 Press Esc to return to the Array menu.

Stopping the Array Initialization Process

If you need to change the disk drives or some other array
configuration, you can stop the array initialization process.
After you stop the process, the array is marked as offline and
cannot be used. You must delete the array before you can use the
disk drives in another array.
To stop the array initialization process:
1 From the System Menu, select Array Menu and press Enter.
The Select Array menu appears.
2 Select the array you want and press Enter.
That array's Array menu appears.
3 Select Abort Initialization and press Enter.
The system confirms that you want to stop the initialization
process.
4 Select Yes and press Enter.

Verifying an Array

The Verify Function allows you to verify the data on specified
arrays:
RAID 3, RAID 4, RAID 5, and RAID 50—Verifies all parity
I
blocks in the selected array and corrects any bad parity.
Mirrored—Compares the primary and secondary disk drives. If
I
a mismatch occurs, the primary is copied to the secondary.
You should verify an array when you suspect there is a problem.
Creating and Managing Arrays and Partitions
↓
key to scroll through the disk drives. These are
2-13