Installation; About This Chapter; Initial Installation - Metrohm 883 Basic IC plus Manual

3.1 About this chapter

3 Installation

3.1 About this chapter
3.2

Initial installation

8
￭￭￭￭￭￭￭￭
The Installation chapter contains:
this overview.
￭
a brief set of instructions for the initial installation of the 883 Basic IC
￭
plus (see chapter 3.2, page 8). At each step, you will find cross-ref-
erences to comprehensive installation instructions for the individual
components if you need more detailed information.
an installation diagram (see chapter 3.3, page 11), showing a fully
￭
installed 883 Basic IC plus.
several chapters (see chapter 3.4, page 14 and the following ones)
￭
with detailed installation instructions for all components, including
those that are already installed at the time the instrument is delivered.
NOTICE
Some of the capillaries are already connected when the instrument is
delivered.
You still have to carry out the following steps:
Installing the 883 Basic IC plus
1 Setting up the instrument
(see chapter 3.4, page 14).
2 Installations on the rear of the instrument
Place the detector in the instrument and connect it (see chapter
￭
3.6.1, page 17).
Remove the transport locking screws (see chapter 3.6.2, page
￭
18).
Connect the drainage tubings (see chapter 3.6.3, page 19).
￭
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
883 Basic IC plus