Installation; Setting Up The Instrument; Packaging; Checks - Metrohm 889 IC Sample Center Basic Manual

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭

4 Installation

4.1

Setting up the instrument

4.1.1

Packaging

4.1.2

Checks

4.1.3

Location

4.1.4

Removing the device from the packaging

889 IC Sample Center Basic
The instrument is supplied in protective packaging together with the sepa-
rately packed accessories. Keep this packaging, as only this ensures safe
transportation of the instrument.
Immediately after receipt, check whether the shipment has arrived com-
plete and without damage by comparing it with the delivery note.
The instrument has been developed for operation indoors and may not be
used in explosive environments.
Place the instrument in a location of the laboratory which is suitable for
operation and free of vibrations and which provides protection against
corrosive atmosphere and contamination by chemicals.
The instrument should be protected against excessive temperature fluctua-
tions and direct sunlight.
Grip the device at the positions marked with arrows and lift it out of the
packaging.
Figure 6 Unpacking the 889 IC Sample Center Basic
Grip the device underneath with both hands when you are transporting it.
Always hold the device in an upright position.
Before you switch on the 889 IC Sample Center Basic, allow the device to
stand for at least one hour in order to adapt to the room temperature.
4 Installation
15
￭￭￭￭￭￭￭￭