Table of Contents
Advertisement
n Front Panel
n Remote
The LASer:OUTput command turns the selected channel's laser output on or off.
SYNTAX DIAGRAM
:
PARAMETERS
An <nrf value>; 1 = on, 0 = off.
POINTS OF
INTEREST
After the selected channel's output is turned on, it may be useful to wait until the output is fully
on before performing further operations, but it is not necessary. When the LAS output is
turned on, there is a two second delay before the LAS output is actually enabled. This is a
safety requirement.
When a Laser output is off, an internal short is placed across the output terminals.
EXAMPLES
"LAS:LDI 20; LAS:OUT ON" -action: sets the selected channel's laser output current to 20 mA
and then turns the selected channel's output on.
"Las:Out 0" -action: turns the selected channel's laser output off.
n Front Panel
n Remote
The LASer:OUTput? query returns the status of the selected channel's laser OUTPUT switch.
SYNTAX DIAGRAM
PARAMETERS
None. The response is an <nrf value>.
POINTS OF
INTEREST
Although the status of the switch is on, the selected channel's output may not have reached
the set point value.
EXAMPLES
"Las:OUT?" -response: 0, means that the selected channel's OUTPUT switch is disabled;
devices may be safely disconnected or connected at the selected channel's output terminals.
"LAS:OUT?" -response: 1, means that the selected channel's OUTPUT switch is enabled, Laser
output current is present for the selected channel.
COMMAND REFERENCE
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
:
LAS
OUT
:
:
LAS
PAGE 33
LASer:OUTput
<white
<nrf
space>
value>
LASer:OUTput?
?
OUT
CHPT 4
Advertisement
Chapters
Table of Contents
