ILX Lightwave LDC-3916338 User Manual page 53

n Front Panel
n Remote
The LASer:CAL:LDI command is used to enter the Laser current set point, measurement, and limit calibration
mode for the selected channel.
SYNTAX DIAGRAM
PARAMETERS None.
POINTS OF
INTEREST Since the limit circuit is the same for both high and low bandwidth modes, it is only calibrated
once. Both low and high bandwidth are calibrated during this procedure.
After this command is issued, the LDC-3916338 Laser Diode Current Source will allow
calibration of the current set point, measurement, and limit. This procedure is outlined in the
Calibration section of the Laser module instruction manual.
EXAMPLES "Las:CAL:LdI" -action: the LDC-3916338 Laser Diode Current Source enters calibration mode
for Laser current.
"Las:Cal:LDI" -action: the LDC-3916338 Laser Diode Current Source enters calibration mode for
Laser current.
n Front Panel
n Remote
The LASer:CAL:LDV command is used to enter the Laser voltage measurement calibration mode for the
selected channel.
SYNTAX DIAGRAM
PARAMETERS None.
COMMAND REFERENCE
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
:
:
LAS
:
:
LAS
PAGE 8
LASer:CAL:LDI
:
CAL LDI
LASer:CAL:LDV
:
CAL
LDV
CHPT 4