Jeio tech Lab companion SI-300 Operating Instruction page 65

④ Pattern save
- Save programmed pattern.
- File extension is PIT.
- Choose a folder and write a file name. Then, click save button.
⑤ Pattern open
- Choose a pattern file and click open.
⑥ Start
- Click the START icon to operate the equipment after pattern is set.
Note: i) If the main body is under abnormal condition such as Door Open, Over Temp.
and etc, the main unit will not operate.
ii) The main body must be set as a Con.P mode. To convert to Con.P mode, press
and hold the lock button for more than 1 second. If you want to operate the unit
in Con.L mode (Local mode), press and hold lock button for more than 1 second.
(Only lock button works in the display panel of main body at a Con.P mode)
- If you set the number of pattern repetition, the main body will work as programmed.
- If you check " Deleting the previous data" option and press a start icon, all the
previous data will be erased. Please, be cautious.
※ Caution
Page 64
Pic 4. Step information and control option.