Introduction - Jeio tech Lab companion SI-300 Operating Instruction

5. Introduction

※ SI-300R/600R
(1) Cover
Easy to observe the sample through Acrylid.
(2) Over Temp. limit
This the safety device which is independent of the circuit.
The Heater reaches over the setting value, the controller shutdown of the
main power
Completely. the over temp. LED illuminates with audible Beep sound.
When the power is shut down, Please set the Knob over 15% than the setting
value.
Press the Start/Stop switch, and then Check the Temp LED illumination.
(3) Communication Port
The serial interface RS-232 can connect the PC through COM1 or COM2 port.
It's allow to check the condition of the unit and the setting value.
This interface can restore the data and then print out.
(4) Body
※ SI-300/600
※ Back side
Page 13