How To Change The Orbital Motion And Reciprocation Motion - Jeio tech Lab companion SI-300 Operating Instruction

7. How to change
the orbital motion and reciprocating motion
motion
Orbital
① Carefully remove the Shaking Table(Part 1) after loosing 4pieces of 5mm Wrench
Bolt.
② Remove 4pieces of the Spacer(SI-300/300R : M5X23, SI-600/600R : M5X28) fixed on
the Vibration Frame.
③ Connect the Spacer (referred Page 6) to the Vibrating Frame for linear motion
④ Position the Shaking Table on the Spacer, tight 4 pieces of 5mm Wrench Bolt.
⑤ The basic usage is the same as the orbital motion.
⑥ When changing the Orbital motion or Reciprocating motion. Must change the Spacer.
→ The operator can use the Orbital motion or Reciprocating motion whatever wants.
Page 38
2
1
Reciprocating