Table of Contents
Advertisement
Figure 52. Removing the processor
Next steps
1.
Replace the
processor.
Installing the processor
Prerequisites
1. Follow the procedure in
2.
Remove the air
shroud.
3.
Remove the heat
sink.
Steps
1. Align the pin-1 indicator of the processor with the triangle on the system board.
CAUTION:
Do not use force to seat the processor. When the processor is positioned correctly, it engages
into the socket at ease.
2. Place the processor in the socket.
3. Close the processor shield by sliding it under the retention screw on the system board.
4. Lower the processor shield lever and push it under the tab to lock the processor shield.
Figure 53. Installing the processor
Next steps
1.
Install the heat
sink.
2.
Install the air
shroud.
3. Follow the procedure in
54
Installing and removing system components
Before working inside your
After working inside your
system.
system.
Advertisement
Table of Contents
