Table of Contents
Advertisement
b. Push the expansion card riser filler bracket downward until firmly seated.
c. Close the blue expansion card retention latch by pushing the latch down until the latch snaps into place.
d. Using a Phillips #2 screwdriver, tighten the screw to secure the expansion card riser filler to the chassis.
4. Using a Phillips #2 screwdriver, fasten the screw to secure the expansion card riser filler to the chassis.
Figure 38. Installing the expansion card riser filler
Next steps
1.
Replace the expansion card
Installing the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If applicable,
install the expansion card in the expansion card
4. Open the expansion card riser latch.
Steps
1. If applicable, remove the expansion card riser filler bracket by performing the following steps:
a. Open the blue expansion card retention latch lock.
b. Using a Phillips #2 screwdriver, remove the screw securing the expansion card riser filler to the system board.
c. Slide the expansion card riser filler bracket up and out of the system.
42
Installing and removing system components
riser.
Safety
instructions.
Before working inside your
system.
riser.
Advertisement
Table of Contents
