Upgrading The Adept Ace Software; Re-Enabling The Write Filter; Checking The Write Filter Status; Setting The Ip Address - adept technology SmartVision EX User Manual

Upgrading the Adept ACE Software

1. From the Adept ACE upgrade files, run autorun.exe.
NOTE: If the upgrade does not change the Adept ACE version number, the write
filter may not have been disabled.
2. Reboot the Adept SmartVision EX.

Re-enabling the Write Filter

1. From the Windows desktop screen, click Start > All Programs > FBWF > FBWF Enable.
A window will display a message that the write filter will be enabled after the next reboot.
2. Reboot the Adept SmartVision EX.

Checking the Write Filter Status

From the Windows desktop screen, click Start > All Programs > FBWF > FBWF Information.
A window will display the current status of the write filter.

Setting the IP Address

NOTE: The Adept SmartVision EX runs XP embedded, so you change the IP
address the same way as you would on a PC.
NOTE: This change will only be permanent if the file-based write filter was
disabled when the Adept SmartVision EX last booted.
1. Click Start > Network Connections.
2. Right-click on the local area connection you want to change.
3. Click Properties.
4. Scroll down to Internet Protocol (TCP/IP) and click on it.
5. Click Properties.
6. Click the radio button "Use the following IP address:".
7. Enter your IP address and a subnet mask of 255.255.0.0.
8. Click Ok.
9. Click Ok again to close the local area connection window and save settings.
Adept SmartVision EX User's Guide, Rev B
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Local Configuration
63