Adding A Camera To The Workspace; Figure 6-3. Adding A Camera - adept technology SmartVision EX User Manual

Adding a Camera to the Workspace

1. Right-click in the blank space below the folder in the Workspace Explorer (on the left
side), then select New > Vision > Device > Basler Pylon Device.
2. Make sure that the "Create a virtual camera" box is checked.
3. Highlight the camera name under Available Devices and click Finish.
In the following illustration, the camera name is a601f (cdf13801533000). The a601f is a
Basler model number; the parentheses contain a serial number. Your numbers will vary.
4. Click the Basler Pylon Device tab.
If the camera name is already displayed in the Device Name field, skip to
a. Select Configuration > Device Name.
b. Click the down arrow, to display the available cameras.
c. Click the camera name.
5. Click View > Vision Window. This will put a tab for the Vision Window beneath the
operating window and open the Vision Window.
Drag the Vision Window, by its title bar, to the bottom or right position locator, so you
can see both the Workspace and Vision Window at the same time. Make sure your
window is large enough to display both the Workspace and the Vision Window.
6. Click the Basler Pylon Device Virtual Camera tab:
If the tab for the virtual camera is not displayed, double-click on the Basler Pylon Device
Virtual Camera object in the left pane to open the object editor and create a tab for it.
a. Click Configuration > Device.
b. Click the down arrow, to display the available devices.
Adept SmartVision EX User's Guide, Rev B
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Starting Adept ACE and Creating an Example Workspace

Figure 6-3. Adding a Camera

Step 5.
49