Stack Mounting; Connecting Power; Figure 3-4. Stack-Mounting The Adept Smartvision Ex And Smartcontroller Cs - adept technology SmartVision EX User Manual

Stack Mounting

To stack-mount the Adept SmartVision EX, install two brackets on each side of the units, as shown
in the following figure. Use the brackets and screws from the bracket kit.
The Adept SmartVision EX, Adept SmartController, and Adept sDIO all share the same footprint,
and can be stacked in this way.
26.9 120.9
16 Typ.
30.7
76.5
186.5

Figure 3-4. Stack-Mounting the Adept SmartVision EX and SmartController CS

3.3

Connecting Power

The Adept SmartVision EX requires filtered 24 VDC power.
NOTE: You must provide your own power supply. Make sure the power cables and
power supply conform to the specifications in the following table.
Refer also to "Connecting an Adept SmartVision EX to a SmartController" on page
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2x 40356-00002
Both sides
8x M3 x 6MM SCREWS
Both sides
Adept SmartVision EX User's Guide, Rev B
328.9
R
155.9
IEEE-1394
Device Net Eth 10/100
OK HPE LAN SW1 1.1 1.2
SF ES HD 1 2 3 4
ON
OFF
1 2 3
XDIO XSYS
XUSR
Connecting Power
*S/N 3561-XXXXX*
RS-232/TERM RS-422/485
XFP XMCP
XDC1 XDC2
24V 5A
- + - +
29.
25