Figure 5-5. Internal 24 V Power Plug - adept technology SmartVision EX User Manual

Chapter 5 - Options
3. Remove the PCIe blanking plates.
One blanking plate covers each empty expansion slot. If you are replacing an existing
PCIe card, the blanking plate will have already been removed.
4. Install the PCIe card. Ensure that it physically clicks into place.
5. Attach the PCIe card to the frame with a thumbscrew. See the preceding figure.
6. For 1394 cards, plug the power cable into the PCIe card.
If the 24 V power cable is cable-tied to other wires, cut the cable tie to free enough wire to
reach the PCIe card.
NOTE: GigE cards do not need a 24 V power connection. A GigE camera,
however, requires 24 V supplied at the camera.
The I/O card does not require a 24 V power connection.
44
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Figure 5-5. Internal 24 V Power Plug

Adept SmartVision EX User's Guide, Rev B
Internal
24 V plug
Thumbscrew