Output Specifications; Typical Output Wiring Example; Installing Pcie Cards; Figure 5-4. Typical User Wiring For Output Signals - adept technology SmartVision EX User Manual

Output Signals
The sixteen digital outputs (1 - 16) share a common, low side (sinking) driver IC. The driver is
designed to supply any kind of load with one side connected to 10 to 30 VDC. The driver does not
include short-circuit protection and the user must take care to prevent shorts. An overload may
damage the driver circuit. Internal "fly-wheel" diodes are included for driving inductive loads.
The VDD power pin must be connected when driving inductive loads.
The outputs are accessed through a direct connection to the 50-pin connector, or through the
optional terminal block.

Output Specifications

Parameter
Power supply voltage range
Operational current range, per
channel

Typical Output Wiring Example

Adept-Supplied Equipment
5.6

Installing PCIe Cards

The Adept SmartVision EX provides two expansion slots for PCIe cards. This section gives
instructions for installing a PCIe card.
1. Remove the top cover of the Adept SmartVision EX.
2. Unplug the internal 24 V plug.
This makes installation of the PCIe cards easier.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Table 5-3. I/O Card Output Specifications

Wiring
Terminal
Block
VDD 1, 26
12
Output 1
11
Output 2
10
Output 3
33
Output 14
30
Output 15
31
Output 16
Output Gnd
25, 50

Figure 5-4. Typical User Wiring for Output Signals

Adept SmartVision EX User's Guide, Rev B
Value
10 to 30 VDC
≤ 62.5 mA, all channels active
I
out
≤ 500 mA, one channel active
I
out
User-Supplied Equipment
Typical User Loads
Load
Load
Load
10 - 30 VDC
Installing PCIe Cards
+
-
43