Testing The Pcie Camera-Support Cards; Testing The Pcie I/O Card; Minimum Adept Ace Revision; Test Procedure - adept technology SmartVision EX User Manual

Table of Contents

Advertisement

Chapter 6 - PCIe Card Check
c. Select the Basler Pylon device, and click OK.
d. In the Calibrations pane, click the
e. Select either Grid or Fixed Pixel Calibration, then click Accept.
Because you are only checking that the camera port works, selecting Fixed Pixel
calibration will save you the effort of performing a calibration with a calibration grid.
f. If you selected Grid Calibration, click the
then click Stop.
Set Dot Pitch to the grid you are using (typically 10 mm).
Click Calibrate, then Accept.
The appropriate calibration unit in the Calibrations pane should now have a check mark.

Testing the PCIe Camera-support Cards

1. For 1394 cameras, test all ports:
a. Click the
b. Click
2. If there are two PCIe cards for camera support installed, test the second card, too.
3. After testing all the camera support ports, exit Adept ACE.
Click No when asked to save the workspace.

Testing the PCIe I/O Card

NOTE: If you get no response from the I/O card, check the event log in Adept
ACE. If the line:
"Optional IO board not installed"
is shown, the Adept SmartVision EX or Adept ACE are not recognizing the I/O card.

Minimum Adept ACE Revision

The driver for the Adept SmartVision EX PCIe I/O card is shipped concurrent with Adept ACE
2.2 (image part number 28962-203) and later.

Test Procedure

You will need something connected to the inputs and outputs of the card to verify that it is
functioning correctly.
1. Connect the cable and terminal block to the I/O card.
2. Connect an appropriate device, such as an LED, to one or more of the card outputs.
This can be anything that will indicate that the card is, in fact, turning on the output line
that you select.
See the pinouts for the output channels. See
page 39
3. Open Adept ACE.
50
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Live icon to verify that the port works.
Stop.
Adept SmartVision EX User's Guide, Rev B
Add icon.
Live icon, focus the camera on the grid,
Table 5-1, "I/O Card Pin Assignments," on

Advertisement

Table of Contents
loading

Table of Contents