Table of Contents
Advertisement
Chapter 3 - Installation
24 VDC Power Specifications
Table 3-1. Specifications for 24 VDC User-Supplied Power Supply
Customer-Supplied Power
Supply
Circuit Protection
Power Cabling
Shield Termination
Vendor Name
XP Power
Mean Well
Astrodyne
NOTE: The power requirements for the user-supplied power supply will vary
depending on the configuration of the Adept SmartVision EX and connected
devices. A minimum configuration requires 3.0 A at 24 VDC. However, a 24 V,
6 A power supply is recommended to allow for additional current draw from
connected devices, such as external IEEE 1394 devices and digital I/O loads.
24 VDC Power Cabling
In order to maintain compliance with EN standards, DC power must be delivered over a shielded
cable, with the shield connected to the frame ground at both ends of the cable, as shown in the
following two figures. Conductors should be 1.5 mm
maximum length for the 24 VDC cable is 10 meters.
26
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
24 VDC (-10%, +5%), 150 W (6 A)
Not more than 8 A (below the
amperage rating of the cable used)
1.5 - 1.85 mm
full-cover, braided shield cable,
maximum length 10 meters
Braided shield connected to the
marked frame ground screw on the
front of the Adept SmartVision EX
(near the XDC connector). On the
other end of the cable, the shield
should be connected to the power
supply chassis.
CAUTION:
Make sure you select a 24 VDC power supply
that meets the specifications in the preceding table. Using
an underrated supply can cause system problems and
prevent your equipment from operating correctly. See the
following table for recommended power supplies.
Table 3-2. Recommended 24 VDC Power Supplies
Model
JPM160PS24
SP-150-24
ASM150-24
Adept SmartVision EX User's Guide, Rev B
2
(16-14 AWG),
Ratings
24 VDC, 6.7 A, 160 W
24 VDC, 6.3 A, 150 W
24 VDC, 6.66 A, 150 W
2
2
- 1.85 mm
(16 to 14 AWG) in size. The
Advertisement
Table of Contents
