SeaDoo 3D Manual page 92

smr2005-050-003_a
787 RFI ENGINES — FRONT AND RH SIDE OF ENGINE
1. Rotary valve shaft oil supply hose
2. Oil injection pump supply hose
– Install a hose pincher to rotary valve shaft oil
return hose.
smr2005-050-004_a
717 ENGINES — LH SIDE OF ENGINE
1. Rotary valve shaft oil return hose
smr2005-050
Section 04 LUBRICATION SYSTEM
Subsection 01 (OIL INJECTION SYSTEM)
smr2005-050-005_a
787 RFI ENGINES — LH SIDE OF ENGINE
1. Rotary valve shaft oil return hose
Connect the pump gauge tester (P/N 295 000 114)
to oil injection reservoir vent check valve.
295000114
TYPICAL
1. Connect pump to check valve
– Pressurize oil system to 21 kPa (3 PSI). The
system must maintain a pressure for at least 10
minutes. Never pressurize over 21 kPa (3 PSI)
– If pressure is not maintained, locate leak and
repair/replace component leaking. To ease leak
search spray a solution of soapy water on com-
ponents, bubbles will indicate leak location.
CAUTION: If any leak is found, do not start the
engine and wipe off any oil leakage.
Disconnect pump gauge tester and remove hose
pinchers.
www.SeaDooManuals.net
75