SeaDoo 3D Manual page 60

CAUTION: Do not modify air intake system,
otherwise calibration will be affected.
Flame Arrester Base
On 717 engines, apply Loctite 518 (P/N 293 800
038) on mating surfaces of flame arrester base
no. 9.
Apply Loctite 243 (blue) (P/N 293 800 060) on
screws no. 10 and torque to 10 N•m (89 lbf•in).
Flame Arrester Base Supports
On 717 engines, before installing arrester sup-
ports no. 11 to flame arrester base no. 9, apply
Loctite 518 (P/N 293 800 038) around each holes
of retaining plate. Apply the product on side to-
ward the base.
Flame Arrester
Inspect condition of flame arrester no. 6. Replace
or clean as necessary.
WARNING
Do not operate watercraft without flame ar-
rester.
Gasket
Inspect condition of gasket no. 2. Make sure to
properly install gasket.
smr2005-047
Subsection 01 (AIR INTAKE SYSTEM)
www.SeaDooManuals.net
Section 03 ENGINE SYSTEM
41