SeaDoo 3D Manual page 24

A: ADJUST
C: CLEAN
I: INSPECT
L: LUBRICATE
R: REPLACE
T: PROCEED WITH TASK
PART/TASK
GENERAL
Lubrication/corrosion protection
ENGINE
Support and rubber mount
Exhaust system fasteners (5)
RAVE valve (if so equipped) (5)
Counterbalance shaft oil level (if so equipped)
Spark plug (4)(5)
Ignition timing (5)
Air intake silencer fit/tightness
COOLING SYSTEM
Flushing
Hose and fasteners
Engine drain tubes
Water flow regulator valve (if so equipped)
FUEL SYSTEM
Throttle/choke cables (carburetor equipped models)
Fuel filter (except RFI models)
Fuel injection system sensor (except throttle body) (RFI models)
Fuel lines, connections (RFI), check-valve, relief valve and fuel system
pressurization (5)
Carburetor/throttle body (RFI), fuel rail and fittings (if so equipped) (5)
Fuel tank straps
LUBRICATION SYSTEM
Oil injection pump (5)
Oil lines
Oil filter
Oil reservoir straps
smr2005-042
Subsection 01 (MAINTENANCE CHART)
GTI SERIES
FIRST 10 HOURS
(1)
I
I
I
I
T (3)
I
I (1)
(1)
I I
I
I I
I
I
I
I I
I I
I
www.SeaDooManuals.net
Section 01 MAINTENANCE
EVERY 25 HOURS OR 3 MONTHS
EVERY 50 HOURS OR 6 MONTHS
EVERY 100 HOURS OR 1 YEAR
T (1) Every 10 hours in salt water use.
I
I
C C
(4) Replace at 150 hours or after 2 years,
I I whichever comes first.
(5) Emission-related component.
R
I
I
I
(1) Every 10 hours in salt water use.
(3) Daily flushing in salt water or foul water use.
I
I,A,L
R
I
(1) In salt water use.
(5) Emission-related component.
I
I
I
(5) Emission-related component.
R
LEGEND
3