SeaDoo 3D Manual page 320

Section 10 STEERING SYSTEM
Subsection 02 (OFF-POWER ASSISTED STEERING (O.P.A.S.))
Torque Phillips screws no. 19 to 2.2 N•m
(19 lbf•in).
Cross Support Plate
For LH Side Cross Support Plate
Remove inlet hose, exhaust pipe and muffler (re-
fer to EXHAUST SYSTEM).
For RH Side Cross Support Plate
Remove resonator (refer to EXHAUST SYSTEM).
Removal
Remove side vane no. 1 and cylinder support no. 6
as mentioned above.
Unscrew the screw no. 22 retaining cross support
plate no. 21 to hull.
1
smr2005-067-003_a
1. Remove screw
Remove cross support plate from the inside of
bilge.
Inspection
Check for cracks and deterioration of screw
threads on cross support plate, replace if neces-
sary.
Verify the condition of gasket no. 23 before instal-
lation, change if necessary.
310
1
F18K1BA
1. Gasket
2. Support plate
Installation
Assembly is the reverse process of disassembly,
make sure of the following when doing assembly:
Install the gasket on the cross support plate.
F18K1CA
GASKET INSTALLED ON SUPPORT PLATE
Inside the bilge, install the cross support plate.
Place the gasket against the hull then align the
holes.
Apply silicone sealant (clear) (P/N 293 800 086)
in hole of screw no. 22 then torque screw to
1.2 N•m (10 lbf•in).
www.SeaDooManuals.net
2
smr2005-067