SeaDoo 3D Manual page 157

Subsection 03 (COMPONENT ADJUSTMENT, INSPECTION AND REPLACEMENT)
F07F0SA
1. Loosen screws retaining the fuel rail
Remove the fuel rail with both fuel injectors.
To remove the fuel injector from the fuel rail, pry
off the retaining clip.
1. Pry the clip
– Carefully inspect O-rings condition before re-
installing fuel injectors. Replace O-rings with
new ones if damaged.
When reinstalling the fuel injector, install the re-
taining clip to the injector, then insert the injector
into the fuel rail.
Apply a thin layer of injection oil to O-rings of fuel
injectors to ease fuel rail installation.
– Check injectors to ensure there is no leak.
WARNING
If a leak is present, immediately stop the en-
gine. Do not use engine until the leak is re-
paired.
smr2005-056
1
www.SeaDooManuals.net
Section 06 ENGINE MANAGEMENT (RFI)
143