SeaDoo 3D Manual page 265

Section 09 PROPULSION
Subsection 02 (DRIVE SYSTEM)
TYPICAL
1. Closing hooks
– Squeeze pliers. When both large and small
windows are directly over the 2 locking hooks,
press those windows down to engage hooks
in windows.
NOTE: At installation, clamp tail should be in op-
posite direction of engine rotation.
1. Engine rotation (counterclockwise)
2. Tail in opposite direction
Small Clamp
Unfasten small clamp no. 3 of PTO
flywheel boot as follows:
– Use Caillau pliers (P/N 295 000 054).
254
F01B1TA
– To open clamp, place flat side of pliers on clamp
embossment, squeeze and twist pliers.
To secure small clamp, do the following:
Place notch side of pliers on clamp embossment
and squeeze pliers.
1. Squeeze pliers
www.SeaDooManuals.net
smr2005-063