SeaDoo 3D Manual page 37

Section 01 MAINTENANCE
Subsection 03 (STORAGE PROCEDURES)
smr2005-044-003_A
1. Water supply hose
Install a temporary hose on the engine fitting. To
avoid hose bending, remove the storage tray and
insert the hose by this opening.
smr2005-044-004
Insert a funnel into the temporary hose and pour
antifreeze in engine until the colored solution ap-
pears at the cooling system bleed outlet. Use a
container to recover the water/antifreeze.
16
COOLING SYSTEM BLEED OUTLET
1. Recover water/antifreeze from this outlet
Place a container at rear of watercraft to recov-
er the water/antifreeze from the vehicle hose
adapter.
Remove the 2 small hose pinchers from the en-
gine drain hoses.
Most of the antifreeze will drain out when remov-
ing the hose pinchers. Use a container to recover
it. DISPOSE ANTIFREEZE AS PER YOUR LOCAL
LAWS AND REGULATIONS.
Install the water supply hose and remove the large
hose pincher.
To protect the exhaust parts, do the following.
Disconnect the anti-rollover bypass hose from the
calibrated elbow on the tuned pipe water jacket.
smr2005-044-006_A
1. Calibrated elbow
2. Air intake silencer
3. Tuned pipe
www.SeaDooManuals.net
smr2005-044