SeaDoo 3D Manual page 311

Section 10 STEERING SYSTEM
Subsection 01 (STEERING SYSTEM)
TORQUE SEQUENCE
Lubricate friction areas and bushings no. 50 with
synthetic grease (P/N 293 550 010) then slide
bushings against blocks no. 20.
Position compress spring no. 21.
Install pin no. 23. Hold latch lever depressed.
300
Install handlebar on steering support then upper
clamps no. 18. Position pin no. 23 into slots of
blocks no. 20.
Using synthetic grease (P/N 293 550 010) lubricate
pin no. 23 and the notches on blocks no. 20.
Position handlebar vertically then torque screws
no. 17 in a criss-cross sequence.
Snap cover of steering padding support no. 16 on
screw heads.
www.SeaDooManuals.net
smr2005-066